Customer
Reviews
Shawn from San Jose, CA: Service Rating
= 
Product
Rating =
Product Use = Part Time/Hobby
The XX
punch has been made for decades, has oodles of different punches
available for it, and is really tight so if you need close tolerance
holes, the punches to do it are available and they will punch
those square shaped holes. It takes forever for the mechanism
to loosen up, so it does take a strong arm to both hold it in
place and then punch with it. If you can make the hole with the
no.5 punch, it is a lot easier but for odd shaped holes and for
more power, the XX is the punch for all time.
Stephen from Pittsburgh, CA: Service Rating
= Product
Rating = 
Product Use = Part Time/Hobby
No. 5
JR HAND PUNCH - Sheet metal is a little hard to punch with it,
but it is very accurate since you can see through the bottom to
line up your mark & hole. Very solidly built - stronger than
most tools I use, and even when you wear out the punch you like
most, all you do is replace the worn piece! Needs to include limitations
for materials it is to be used on, I almost had to stand on the
thing to punch 1/8" sheet aluminum. oh and take off the depth
spacer, it makes too much of a thumb slicer if you catch it right.
thankfully only my thumbnail got caught.
