Bend Tech EZ-3D
 |
Multiple Document Interface
Bend-Tech EZ's interface allows for simultaneous viewing, creation,
and changes to several parts.
|
|
Manufacturing
Instruction
Cut length, weight and bending information are available on the
screen and on a printed setup sheet. A bend identifier refers back
to the template design.
|
|
Part Settings Selections
Tooling and Material selection are based upon your inventory. Display
settings include decimal or fractional output and bend dimension
locations.
|
|
|
With
Bend-Tech EZ-3D
bitmaps, like the one shown below, are
displayed on a secondary setup sheet describing every movement
of the manufacturing process.
|
Bend-Tech
EZ-3D is designed for the serious hobbyist. It uses 100% the
functionality of Bend-Tech EZ and also includes the following:
-
3D Tri-Star input using simple terms such as; to front, to back,
to left, to right, to ceiling and to floor
-
Outputs
Rotation
-
Simulation
-
Secondary
Setup Sheet showing thumbnails of movement transitions
-
Start
production from either end and
flip part in the middle of manufacturing
-
Increased
Bend Allowance and Start of Bend location formulas
-
60
page users manual
System Requirements
- Windows 98
or newer (Vista compatible, XP Recommended)
|
| There
are dozens of templates to choose from and many more available every
month from the web site www.2020ssi.com/bend-techez/templates.
Most templates are available in center line, outside and inside dimensions. |
See
a DEMO!
Compare
all 4 Bend Tech Products here!
Bend-Tech
Software is copyrighted by 2020 Software Solutions, Inc.
|
