|
Note: Ineco Tube Bending Machines are no longer available.
Please visit our Used Machines page or click here for our current tube bending machine selection..
Ineco QB-50 VDM and QB-50 VDE Tubing Benders
 QB50
available in either VDM (shown) using a manual hand wheel
for positioning of the CB (counterbend die), or VDE model
which incorporates motorized CB die positioning.
- Maximum capacity:
up to 2" OD tube (mild steel, .120" wall thickness). Wide
range of bend radii available from 3/8" to 8-3/4" CLR.
- Tooling available
to bend round, square, rectangular tube, and profiles or special
shapes.
- Variable
bending speed: adjusted by potentiometer on control panel
(>/=11.5 seconds for 180°). Allows operator to set required
speed for various material; i.e stainless and chromoly require
slow speed settings.
- Microprocessor
Control Unit: bending angle, springback factor, and zero position
of counterbend die shaft (VDE model only) are fully programmable
and monitored thru the control panel.
- User friendly
programming: easy step by step method. Capable storing of
25 different programs with up to 10 sequential bends per program.
- Electronic
overload device: automatically protects the mechanical system
from possible damage caused by oversized material and / or excessive
bend speed.
- Backlit LCD display enhances ease
of operating and programming.
- Low maintenance:
requires lubrication of counterbend die only.
- Quick
change tooling.
- Portable:
built in wheels and extractable handles.
- Available
in single phase, or three phase with multiple voltage settings.
- Download
the INECO Tube Bending
brochure (PDF format)
-
 Click here to see a video! (4mb windows media
format)
|
