JMR High Capacity Tube & Pipe Notcher

The JMR Tubing and Pipe Notcher is the highest quality and one of the most versatile hole saw notchers on the market. It is manufactured from bar stock, not plate, to increase strength and has a 1.125" induction hardened shaft supported by Timken™ bearings. The custom designed shaft seals prevent bearing and shaft damage and the shaft accepts replaceable hole saw mounting threads.

Angle changes can be made easy due to a Timken™ thrust bearing at the pivot point to increase clamping force while reducing wrench pressure. Use it for prototyping or production work.

Shim kit included for offset copes

• Capable of notching in a 210° arc
• Easily handles Offset copes with included shim kit
• 2.5" tube, 2" pipe capacity
• Double v-clamp vise allows square to be held flat or corner to corner
• Will hold thin wall tube without distortion
• May be clamped on tube/pipe to bore holes
• Multiple mounting positions
• Engraved degrees and stainless steel pointer ensures accuracy
• Aluminum bronze acme threaded bushing on clamp
  
  Instruction Manual (.pdf)
  
  

Click Here for the best hole saws to use with the TN1000

Ren from Chico, CA:   Product Rating = Service Rating =
Product Use = Part Time/Hobby

When I pulled the JMR tube notcher out of the box I was amazed at the quality, completely enclosed and sealed shaft housing that comes pre-lubricated, no chance for vibration, there were definitely no corners cut in this design. This notcher is much more versatile than many other manual notchers on the market today, with the capability to notch square tubing two ways, and the notcher can achieve angles that most cannot. There is no doubt that this notcher is one of the best manual notchers on the market.

Minh from Fountain Valley, CA:   Product Rating = Service Rating =
Product Use = Part Time/Hobby

JMR products are some of the highest quality products for the back yard fabricator. This notcher vibrates far less then the JD2 notchmaster that I was used to using before. The clamp on the JMR unit is much beefer and holds the tubes tighter. I use this notcher at least 10-20 times a week and absolutely love it. Don't think any other hole saw notcher can beat the JMR unit!