TN-100 Tube Notcher at Van Sant Enterprises' Trick-Tools.com

JD2 TN-100 Tube Notcher

The notcher for the builder who knows quality tools and demands the best. This unit from JD2 is the most popular hole saw notcher on the market. Known for its well machined billet aluminum construction, micro-adjustable and self centering V-style vice, and stainless steel shaft supported by needle bearings, it is sure to get your notching projects done year after year.

Features

Large capacity and low cost - The TN-100 notches 3/4" through 2" O.D. tubing at angles up to 50° in under 20 seconds. It uses commonly available bimetal hole saws costing approximately $10. A single bimetal hole saw will typically notch 3 to 5 complete cars.
Easy to use - The TN-100 may be mounted in a drill press or simply clamped in a vise and used with a 1/2" hand drill. The TN-100 can be laid horizontal when notching 45° angles, so the floor will not interfere with the tubing being notched.
Heavy duty frame - Entirely CNC machined, the frame is made from 1/2" thick 6061-T6 aluminum and its face has been milled flat. The degree increments are then machined directly into the frame so they can't wear off. An all position swivel base ensures easy setup.
Rigid bearing block - This is the most critical part of a hole saw style notcher. The TN-100's bearing block uses twin needle bearings and separate grease seals for maximum rigidity and reliability. A 3/4" ground and polished stainless steel shaft protects against the possibility of rust contaminating the precision bearings.
Strong, accurate tube cradle - As can be seen in the picture, the entire cradle and clamp assembly have been CNC machinined out of a solid steel block so the tube will be notched exactly in the middle. This eliminates the problems of tube walk in notchers that use a U-strap.
Don't be fooled by cheap imitations!

Read customer reviews on this product

Instruction Manual

Accessories

Click Here for hole saws
Don't forget the notching lube! Click here

Customer Reviews

Glenn from Rowland Heights, CA: Service Rating = Product Rating =
Product Use = Part Time/Hobby

The TN-100 works great! Before I purchased it I used a friends notcher (bronze bushings,Cast block degree marking missing) I can't believe the difference. I was able to save time and material due to the more stable and accurate design of the TN-100. I strongly recommend it for prototype work and short run production.

Craig from Duanesburg, NY: Service Rating = Product Rating =
Product Use = Part Time/Hobby

I received my TN-100 notcher last Thursday and it works great. I tried that evening and all weekend without a problem. I was told by a local machinist all I needed to do was use a hole saw in a drill press, but after 6 hole saws and much aggravation I gave up and called you. I looked at all the notchers out there and none came close to the TN-100. The price was right , the quality is outstanding and I wouldn't recommend any other. I look forward to future purchases with you and keep up the good work.